Panasonic TC-P50S60 Technical Manual page 86

Troubleshooting 6 Blinks Failure (TC-P**ST60)
Applies to Models
TC-P50ST60
TC-P55ST60
TC-P60ST60
TC-P65ST60
Verify that all the cables on the SC board are properly seated. Also
check the ribbon cables and connectors on the A and C boards.
Unplug the TV and disconnect connector SC20 on the SC board.
Plug in the TV. Note: If the power LED does not turn on automatically
after the TV is plugged in as expected, then press the power switch.
6 Times
Is the power LED
blinking 6 or 8
Replace the A
board
For S60 models go to
the previous page
Start Here
8 Times
times?
Replace the SC
Blink
Code
6 Blinks
SU SU
SC
SC
SD
SD
SC20
board
List of boards likely to cause this symptom.
No.1 No.2 No.3
SC A
Make sure these
TC-P50ST60
connectors are
properly seated
P
P
A33
A20
No.4
SS33
SS SS
A
A
Slide 86 Slide 86