Preparing For The Remote Control - Hitachi LP-AW4001 User Manual

Preparing for the remote control

Please insert the batteries into the remote control before using it. If the remote
control starts to malfunction, try to replace the batteries. If you will not use the
remote control for long period, remove the batteries from the remote control and
store them in a safe place.
1. Remove the battery cover.
Align and insert the two AA batteries (
2.
AA carbon-zinc or alkaline batteries (non-rechargeable) in
accordance with laws and regulations.
plus and minus terminals as indicated in the remote control.
Put the battery cover back to the former state.
3.
NOTE
control malfunctions.
sensors on the projector using infrared light
(Class 1 LED). The active sensor senses
the remote control signal assigned within 60
degrees to right and left, and within 3 meters.
a strong ray. It may cause malfunction of the
projector and remote control.
WARNING
directed. Improper use may result in battery explosion, cracking or leakage,
types at the same time. Do not mix a new battery with used one.
Make sure the plus and minus terminals are correctly aligned when loading a battery.
If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
Obey the local laws on disposing the battery.
10
"Operating Guide".
Always handle the batteries with care and use them only as
Use the appropriate
) according to their
Remote sensor
30° 30°
3m
(approx.)