Table of Contents
Advertisement
ST2-RC Remote Control Operation
The ST2-RC remote control is the only means of
remote operation of the ST2-XM2 in a non--RNET sys-
tem. The ST2-XM2 front panel displays information for
the tuner that is receiving commands from the ST2-
RC. However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem's source selection.
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
PWR
push
or any other button except TUNER 1 or
TUNER 2.
Selecting the desired tuner
To control a tuner, push
pressed, these buttons will be backlit green for Tuner
1 (XM1) and amber for Tuner 2 (XM2). Each time a
tuner is selected the display will refresh with the cur-
rent station or preset for that tuner, and all subse-
quent button presses and memory preset entries will
be associated with that selected tuner.
Selecting the desired channel
Use
and
for manual tuning. To move quickly
through the channels, press and hold either of the
Tune buttons for more than 1.5 seconds.
To directly select a channel, press
the two- or three-digit XM channel number.
Selecting an XM mode
OK
Push
to select an XM operating mode.
Exiting an XM mode
ST/
Push
to exit the XM operating mode selection
MONO
menu.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
BANK
press
and enter the desired bank number
MEM
(1-6), then press
and enter the desired preset
TUNER 1
TUNER 2
or
. When
TUNE
, and enter
ST2-XM2 OPERATION
ST2-RC REMOTE CONTROL
number (1 to 6). The memory presets can also be
accessed by using
and
presets for the selected bank.
Saving Favorites
The remote control stores two "favorites" (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding
FAV 2
until "FAV1 (2) saved" appears on the tuner.
Stored Favorites are then recalled by pressing either
FAV 1
FAV 2
or
.
to scroll through all
FAV 1
or
19
Advertisement
Table of Contents
