Whirlpool ADO30 Use And Care Manual page 8

Operating your dehumidifier
Control panel
Your dehumidifier has a control panel
containing two controls -the Pan Full Light
and the Humidistat.
Pan Full Llght
- This light glows when the
water pan is full and needs to be emptied.
Humidistat
- This controls the amount of
moisture in the room. When the humidity in
the room rises above the setting, the unit
automatically starts. When the humidity
drops below the setting, the unit automati-
cally stops.
I
PAN FULL HUMIDISTAT
Unit operation
1. Turn the Humidistat to OFF. Plug the
power supply cord into an electrical
outlet. Be sure to use the proper ground-
ing method. See page 5.
PAN FULL HUMIDISTAT
0
2. Turn the Humidistat toward DRYEST for
normal operation. The Humidistat can be
set anywhere between OFF and DRYEST.
If you need more dehumidification, turn the
Humidistat toward DRYEST. If you need
less dehumidification, turn the Humidistat
toward OFF.
3. Turn the Humidistat to OFF to stop the
unit manually.
NOTE:
The dehumidifier will run continu-
ously when the control is set to DRYEST.
PAN FULL
HUMIDISTAT
0
8