AEV PROCAL User Manual page 4

For AEV HEMI Builders Kits, the ProCal Module will:
• Program the Vehicle's VIN into the new PCM
controller (only required for older kits)
• Program the Pedal Calibration and Tolerance
• Adjust transmission settings for your 5.7L or 6.4L
engine on 2012 or newer vehicles
The ProCal Module is only designed to be plugged into
the vehicle during programming or activation of runtime
features. Between uses AEV recommends storing the unit
in the glove box or console. It is important to cycle the key
OFF after any successful programming before starting/
running the vehicle.
The module will lock to a vehicle's VIN number and may
not be used on another vehicle until the "RESTORE"
function is used on the original vehicle. The "RESTORE"
function will reset a vehicle's default settings to stock
and unlock the module for use in another vehicle. It IS
NOT recommended to try and pull a vehicle's settings out
before selling it. Because some transmissions require
altered settings to use different physical axle ratios, the
ProCal once used must remain with those new gears in
the vehicle. It may seem tempting to keep the ProCal
and use it on your new Jeep, but this often leads to
incompatibility with the new or old vehicle. We highly
recommend selling vehicles and including the ProCal
attached to it.
Programming Procedure: Set the DIP switches
accordingly using this User Guide or the Quick Reference
Card. With the engine off and the ignition on, plug the
module into the ODB port and wait for the horn to sound.
If the horn does not sound, consult the troubleshooting
section of these instructions. It is important to cycle
the key OFF after any successful programming before
starting/running the vehicle.
The ProCal is FAST. It will honk very soon after you plug it
in. This is normal.
Unhooking the battery will not remove ProCal settings.