Siemens RUGGEDCOM RX1501 Installation Manual page 36

Hide thumbs Also See for RUGGEDCOM RX1501:

Table of Contents

Chapter 3

Modules

Figure 18: Removing a Power Supply

1. Chassis 2. Power Supply 3. Screws

DANGER!

Electrocution hazard – risk of serious personal injury or death. Make sure power to the module is

turned off before servicing the power supply terminal.

Turn off power to the module.

Disconnect the power supply wiring from the terminal block. Alternatively, for convenience, remove the

terminal block with the wiring still connected and set it aside to be connected later to the new module.

Install a new or blank module to prevent the ingress of dust and dirt.

Installing a Power Module

To install a power module, do the following:

If equipped, remove the existing module.

If applicable, connect the supplied terminal block to the module or connect the terminal block from the

previous module.

Confirm or connect the wiring from the power supply to the module. For more information, refer to

Section 2.6, "Connecting Power"

Insert the module into the empty slot.

RUGGEDCOM RX1501

Installation Guide

Installing/Removing Power Modules

Table of Contents