Instructions - Rainbow Super Funhouse Assembly Instructions Manual

Step 1
*NOTE: Pre-drill holes for all 5/16" Lag Bolts with a 1/8" Drill Bit.
1. Position Corner Posts with Top Joist Holes (227) (6091) and Lower Corner Post (228) (6092) on the
ground with counter-sunk holes in Corner Posts (227) (6091) facing in towards each other. (Diagram
shows assemblies standing up for proper assembly only.)
2. Attach Top Joist (229) (6093) to Corner Posts with Top Joist Holes (227) (6091) using 1/2" Hardware
(H4) and 3/8" Hardware (H3) (H11) (H17) (H28) (H55). Do not thoroughly tighten hardware at this
time.
*SUGGESTION: When installing Facias, put bottom Lag Bolts in first and check that
measurements are correct and assembly is square before inserting top Lag
Bolts.
3. Attach 6 Hole Facia (246) (0067) to Corner Posts (227) (6091) (228) (6092) using 5/16" Hardware
(H108) and 1/4" Hardware (H1). Facia must be flush with the bottom and outsides of Corner Posts,
and the distance between the outside faces of Corner Posts must be 38" and 73" as shown below.
Offset holes must be up (as shown in Inset A).
4. Measure up 65 1/2" on Lower Corner Post (228) (6092) and center Corner Post with Top Joist Hole
(227) (6091) and attach 2 Hole Facia (235) (9133) using 5/16" Hardware (H108) and 1/4" Hardware
(H1). Offset holes must be down (as shown in Inset B).
5. Measure up 49 3/4" and 38 1/4" on Corner Posts (227)
(6091) (228) (6092) and attach 4 Hole Facias (254) (0075)
using 5/16" Hardware (H108) and 1/4" Hardware (H1).
Offset holes must be up (as shown in Inset C).
246
0067
1"
INSET A
235
9133
INSET B
1 1/4"
INSET C
Wall Assembly
228
6092
1 1/4"
2"
254
0075
1 1/2"
H4
H55
235
9133
254
0075
38"
73"
19
COUNTER-SUNK
HOLES MUST FACE IN
H3
229
6093
254
0075
H1
65 1/2"
38 1/4"
227
6091
246
0067
H1
H17
H28
H11
H108
49 3/4"
H108