Table of Contents
Advertisement
RAID Subsystem DVA-08K | Installation Manual
Flashing Green
Static Green
Static Red
OFF
Table 4.5 PSU Module LED Definitions
4.2.7
LCD Keypad Panel
The LCD panel located on the front aluminum foldable handle comes with three status LEDs.
The LEDs are marked from top to bottom "PWR," "BUSY" and "ATTEN" and are clearly seen in
Figure 4.6 below. The definitions of these LEDs are shown in Table 4.6. The mute button can
be used to stop the alarm until the next controller event occurs.
Fig. 4.6 LCD Keypad Panel
Bosch Security Systems
Color
The power supply has not been turned on. The PSU module LED will
blink when the subsystem is connected to a power source but has not
been turned on.
The PSU is operating normally and experiencing no problems
The PSU has failed and is unable to continue providing power to the
subsystem.
The power cord is unplugged or the power cord is plugged but no
power is being supplied from the power source.
Subsystem Monitoring | en
Status
F.01U.027.797 | V1 | 2006.05
27
Advertisement
Table of Contents
