How To Recalibrate; Storage - Jetson V6 Manual

• Battery is low but still being used (the V6 will turn the motor off after 15 seconds).
• Balancing in a neutral position for over 30 seconds.

HOW TO RECALIBRATE

When the V6 experiences an error, the Status Indicator Light will turn red. That means it will not
operate until it is properly recalibrated. Please do not try getting on the unit until the error has
been fixed. To recalibrate, follow these steps:
1. Put the hoverboard on a flat, level surface, with the mat facing up.
2. Press and hold the Power Button for about 5 seconds until the lights on the V6 flash,
and you are notified of a successful calibration.
3. Turn it OFF and then ON again to restart the V6. That completes the recalibration, and
is now ready for use.
• If you plan on storing the V6 for a substantial period of time, please make sure you
fully charge the battery before storing. The battery should be fully charged once a month
after this.
• You should bring the V6 into a warm environment (above 50 degrees Fahrenheit)
for charging.
• To protect against dust, cover the V6.
• Store the V6 indoors, in a dry place and at a suitable temperature.
• Do not leave the V6 plugged into the charger for long periods of time.

STORAGE