Call Up The Gas Cylinder Fill Level; Remaining Time; Resetting The Appliance; Additional Levelcontrol - Truma LevelControl Operating Instructions Manual

The button (5) on the Truma LevelControl must
be pressed briefly every time a gas cylinder is re-
placed. If the button (5) was not pressed after a gas cylinder
was changed, the gas cylinder must be reconfigured under
"Status" -> "Gas cylinders" -> "Configuration", even if the
cylinder type or cylinder size has not changed.
Steel gas cylinders
Remove the Truma LevelControl upright from the gas cylinder
and fit it onto a new gas cylinder.
Aluminium gas cylinders
Danger of cut injuries! Wear protective gloves (con-
forming to EN 388 ref. no. 3221) when securing the
clamping sheet.
Press the swivel plate onto the gas cylinder base and loosen it.
Take the clamping sheet out of the gas cylinder base and se-
cure it to the new gas cylinder.
Gas cylinder update
After changing the gas cylinder, start the Truma App and call
up the gas cylinder fill level.
If the cylinder type or size changes, this must be adjusted
in the Truma App under "Status" -> "Gas cylinders" ->
"Configuration" by selecting the respective Truma LevelControl.
LevelControl magnetic foil
Fit the LevelControl magnetic foil on the new gas cylinder.

Call up the gas cylinder fill level

Call up the "Status" menu point in the Truma App.
8

Remaining time

The Truma App calculates the time in which the remaining
gas will probably be used up. Upon initial start-up or after
the Truma LevelControl has been reset, a standard value is
used that the Truma App adapts based on the measured
consumption.

Resetting the appliance

Keep the button (5) pressed for 20 seconds until the status LED (2)
lights up briefly. The Truma LevelControl is reset to the factory
settings.
The Truma LevelControl must then be reconnected to the
Truma iNet Box.

Additional LevelControl

With two Truma LevelControl, it is possible to read out the fill
level of two gas cylinders parallel via one Truma iNet Box.
A maximum of two Truma LevelControl can be connected to
the Truma iNet Box via the Truma App.
Disconnect the Truma LevelControl from
the Truma iNet Box
Under "Settings" -> "Device manager" -> "Manage Bluetooth
devices" -> "My devices" -> "Remove" select the Truma
LevelControl from the list and confirm.