Preparing Start-Up; Connect The Truma Levelcontrol To The Truma Inet Box; Securing Truma Levelcontrol On A Gas Cylinder - Truma LevelControl Operating Instructions Manual

Preparing start-up

Installing the Truma App on a mobile terminal device
Load the Truma App from the Apple AppStore or Google Play-
Store onto the mobile terminal device.
Install the Truma App on the mobile terminal device.
If necessary, an installed Truma App must be updated.
To continue installation, follow the instructions in the Truma App
or the instructions below.
If the Truma App is to be used on several mobile terminal de-
vices, these steps must be repeated for each mobile terminal
device.
For the remote control to function properly with SMS, it
is necessary for the standard SMS app of your mobile
terminal device to have your phone number as the sender and
not manipulate the text. Under no circumstances may "Web-
SMS connectors" be used.
Connecting the terminal device to the Truma iNet Box
See the operating instructions for Truma iNet Box
Connect the Truma LevelControl to the
Truma iNet Box
Put batteries into the Truma LevelControl. (see "Changing the
batteries")
Make sure that there is a connection via Bluetooth between
the mobile terminal device and the Truma iNet Box.
4
The Bluetooth range is approximately 10 m. The range
can vary depending on the installation position.
Start the Truma App. Select the menu point "Settings" ->
"Device manager" -> "Manage Bluetooth devices" -> "Find
devices".
Briefly press the button (5) on the Truma LevelControl. The
status LED (2) flashes for up to 2 minutes.
Select Truma LevelControl from the list of devices found. Fol-
low the Truma App instructions.
The status LED (2) goes out after a connection is successfully
established.
It is possible to use up to two Truma LevelControl in par-
allel. (see "Additional Truma LevelControl")
Securing Truma LevelControl on a
gas cylinder
Do not pull the Truma LevelControl along the gas cylin-
der base, as this can damage the coupling pad (1). To
reposition, remove the Truma LevelControl from the cylinder
in an upright position and fit it in its new position.
To simplify securing of the Truma LevelControl, it is rec-
ommended to take the gas cylinder out of the gas cylin-
der box and to tilt it slightly or lay it on its side.
The coupling pad (1) must lie on the surface of the gas cylin-
der. If this is not possible due to depressions or flattenings
in the vicinity of the centre of the gas cylinder base or heavy
dirt (e.g. rust), fit the Truma LevelControl as far away from
the centre as necessary in order to guarantee full contact be-
tween the gas cylinder and the coupling pad (1).