Table of Contents
Advertisement
How to install the wired remote controller
1. As shown in the right, connect the remote control cable to the installation board of the wired
remote controller.
* Remote control cable must separately be purchased on site.
2. After fixating the cable on the guide groove, attach the installation board of the wired remote
controller to the location you want.
* Before fixating the remote control cable on the guide groove, remote the blocked part of the
case toward the direction you want to install.
<Front side of wired remote
controller installation board>
3. After locating the wired remote controller installation board at the location you want to install,
tighten the screw to firmly fixate it. (If there is a burial box, install the wired remote controller
installation board to fit the burial box.)
12V
GND
BUS_B
BUS_A
BUS A BUS B GND 12V
BUS A BUS B GND 12V
Top
BUS A BUS B GND 12V
Bottom
4
B GND 12V
3
2
1
Guide groove
<Rear side of wired remote
controller installation board>
Fixate the remote control cable
to the guide groove.
Use the screw to tighten
the board to the wall
Wired remote controller
installation board
Test run
Remote control cable
Wall
Installation Manual 39
Advertisement
Table of Contents
