Cleaning - Panasonic EH-XC10 Operating Instructions Manual

Cleaning

1
1
Rinse foam off the brush with water and then
remove.
2
2
Open the facial cleanser
compartment cover, begin
pouring water into the foam
dispenser, and then press the
facial cleanse switch to rinse.
• If a significant amount of facial
cleanser remains, the power may
turn off a few seconds after pressing
the facial cleanse switch or may not
operate smoothly. In such cases, use
warm water to clean and remove the
excess cleanser.
3
3
Press the facial cleanse switch to turn off the power.
4
4
Manually clean the brushes, warming makeup removal
plate, and around the facial cleanser compartment.
Clean the facial cleanser compartment thoroughly as facial
cleanser tends to accumulate in this area.
• If you become concerned about dirt accumulating in the
brush, apply facial cleanser to the brush and wash it by hand.
• Please note that the bristle portion of the silicone brush may
come off if pulled strongly.
• Please reattach the silicone part if it becomes detached.
EH-XC10_AM.indb 15
5
5
Shake the main body to remove excess water.
6
6
Lightly wipe with a towel or
similar and place on the stand
to dry.
• Leave the facial cleanser
compartment cover open to dry.
• Place the brush and measuring cap
at the rear of the stand.
• After cleaning, store in a location
with low humidity. (Storing the
appliance in an enclosed shower or
bath may cause condensation and
rust to develop inside the main body
leading to failure.)
►Replacement accessories
Replacement accessories are available at your dealer or Service
Center.
Japanese-style soft brush
Pore-targeting silicone brush
EH-2S01
EH-2S02
15
2015/07/21 18:02:25