Samsung TT17J Series Service Manual page 11

4 Alignment and Adjustments
4-1-3 Connecting the SoftJig
Connect the monitor to the signal generator and/
or PC as illustrated in Figures 4-1 and 4-2.
Note: The signal cable connector which includes
the 3-wire cable must connect to the
monitor. If you use Setup 2 (PC only, no
signal generator) you can only make
adjustments to the signal timing available
on that computer system. To make
corrections to all factory timings requires
the use of an additional signal generator.
MONITOR
INTERFACE
BOARD VER. 2.0
5V DC
ADAPTOR
PARALLEL CABLE
PC
Figure 4-1. Setup 1, With Signal Generator
4-2
SIGNAL CABLE
3-WIRE
CABLE
SIGNAL
GENERATOR
INTERFACE
BOARD VER. 2.0
3-WIRE CABLE
5V DC
ADAPTOR
PARALLEL CABLE
PC
Figure 4-2. Setup 2, Without Signal Generator
MONITOR
SIGNAL CABLE
D-SUB
CONNECTOR
TT17J*