Contents Of Kit - AJ Aircraft Laser 230z Manual

Contents of Kit


105" Laser 230z fuselage covered in genuine
Ultracote

Set of Main Wings w/pre-installed hinges and
sealed aileron hinge gap

Set of Horizontal Stabilizers w/pre-installed
hinges and sealed elevator hinge gap

Pre-hinged, removable rudder

5" Carbon Fiber Spinner

Embroidered quilted wing and stabilizer bags
Recommended Equipment

Desert Aircraft 100cc to 120cc gas engine

(2) KS3086 canister mufflers with 90mm
flexible drop header.

(8) x 400+in. oz. high torque digital metal gear
servos for all surfaces

(1) x standard size servo for throttle

Aluminum Servo Arms:
o (6) x 1.75" for ailerons & elevators
(2) x 3.5" for pull/pull rudder or
o
(2) x1.75" for push/pull
Recommended Tools Needed for Assembly

Blue Painters Tape

Denatured Alcohol & Paper Towels

Blue Loctite

Metric & Standard Allen Wrenches

Hobby Knife & Fresh Blades

15 – 30 Minute Epoxy (or Gorilla Glue)

Thin C/A
Recommended CG Range and Control Throws

The center of gravity (CG) for the 105" Laser 230z is located 1 ½", measured from the front of the wing
tube insert located in the fuselage.
 Aileron Control Throws
o Low Rates – 15 deg. (30% Exp)
o Mid Rates – 35 deg. (40% Exp)
o High Rates – 45 deg. (50% Exp)

Carbon fiber wing and stabilizer tubes

Carbon fiber main and tail landing gear

Color matched fiberglass cowl, wheel pants,
landing gear cuffs and canopy

Heavy duty wheels and steel axles

Engine mounting templates

Canister muffler mounts

Basic sheet of vinyl graphics

Individual bags of high quality hardware

9+ Channel Full Range Receiver

Ignition Spark Switch or Optical Kill Switch

Servo extensions:

Electric Drill with Assorted Small Bits

Small Flat Head & Phillips Screwdrivers

Sanding Block & Sandpaper

Needle Nose Pliers

Adjustable Wrench or Socket Set

Measuring Tape & Ruler

Fine-tip Sharpie Marker
 Rudder Control Throws
Low Rates– 15 deg. (30% Exp)
o
Mid Rates– 35 deg. (40% Exp)
o
High Rates– Max Throw (50% Exp)
o
(2) x 24" for outer ailerons
o
(2) x 6" for inner ailerons
o
(4) x 6" for receiver to wing
o
(2) x 48" for elevators
o
(2) x 24" for throttle & ignition
o
(2) x 36" for push/pull rudder (none
o
for pull/pull)
 Elevator Control Throws
o Low Rates– 15 deg. (30% Exp)
o Mid Rates– 35 deg. (40% Exp)
o High Rates – 45 deg. (50% Exp)