Focus Adjustment; Centering - Beehive International B102 Service Manual

the raster width, it should not be used solely for that
purpose. The placement of the linearity sleeve should
be optimized for the best linearity.
(4) Readjust LlOl for proper width.
(5) Observe final horizontal linearity and width, and touch
up either adjustment if needed.
No horizontal hold control is used in this monitor. The raster should be
properly locked and centered when the horizontal drive signals as described in
Section 1.2 are used.
3.6 FOCUS ADJUSTMENT
The focus control, R107, provides an adjustment for maintaining best overall
display focus. However, because of the construction of the gun assembly in
the CRT, this control does not have a large effect on focus.
3.7 CENTERING
If the raster is not properly centered, it may be repositioned by rotating the
ring magnets behind the deflection yoke.
The ring magnets should not be used to offset the raster from its nominal
center position because it would degrade the resolution of the display.
If the picture is tilted, rotate the entire yoke.
A-8