Download
Share
Print this page
aquaforte UltraSieve III Instruction Manual
  1. Manuals
  2. Brands
  3. aquaforte Manuals
  4. Water Filtration Systems
  5. UltraSieve III
  6. Instruction manual

aquaforte UltraSieve III Instruction Manual

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
U
l
t
r
a
S
i
e
v
e
I
I
I
U
l
t
r
a
S
i
e
v
e
®
I
I
I
®
Patent nr: NL 1026138 / EP 1593305 / US 2005/0258188-A1
I
n
s
t
r
u
c
t
i
o
n
M
a
n
u
a
l
I
n
s
t
r
u
c
t
i
o
n
M
a
n
u
a
l

Advertisement

loading
Need help?

Need help?

Do you have a question about the UltraSieve III and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for aquaforte UltraSieve III

Summary of Contents for aquaforte UltraSieve III

  • Page 1 ® ® Patent nr: NL 1026138 / EP 1593305 / US 2005/0258188-A1...
  • Page 2 Introduction The UltraSieve is a pre-filter to filter waste solids from the water. This technique is based upon the sieve-bend. A sieve- bend consists of hundreds of sharp stainless steel profile wires with very small slot openings where the water can go through but the solids stay on the sieve bend (see picture below).

  • Page 3: Pump Connection

    UltraSieve Installation instructions Please read these instructions before you start installing. If you have some questions after reading this manual, please contact your UltraSieve dealer before you start installing to prevent mistakes. The UltraSieve can be installed in 2 ways: Gravity (pond fed), equal to the water level in a direct connection with the bottom drain (and/or skimmer) Pump fed, above the ground with a free flow back to the pond.
  • Page 4 The auto-adjustable dam with floating device The UltraSieve has a floating system to prevent the water in the area under the sieve from rising above the level of the sieve for low speed pumps and also to prevent the water from going too low to be primed for high speed pumps. The floating device can be installed at 3 different levels.
  • Page 5 Filling the floating device Fill the unit with 3 litres of water for counter weight and put the plug in the hole. Pump fed application When you want to use the UltraSieve above the water level with a submersible pump from the pond you must connect the pump hose to the 110mm inlet.

  • Page 6: Maintenance

    Maintenance It is advisable to monitor the UltraSieve every day. Maintenance is very easy because of the waste outlet. In fact maintenance is about two operations: 1. To remove the waste that is on the surface of the sieve (every day). 2.

  • Page 7: Technical Specifications

    Technical Specifications 37 cm 65 cm 99 cm 100mm 94,5mm 181mm 370mm SIZE MATERIAL EXTRA INFO HOUSING 65 x 37 x 99 cm 1 cm polypropylene plate INLET 110 mm spigot Polypropylene 2 x 110 mm inlet OUTLET 2” male threaded 2”...