GPO PR100 Setup Manual

Hide thumbs Also See for PR100:

GPO Retro – GPO PR100

Setup Guide

Thanks for purchasing the GPO PR100. To correctly set up your unit and begin enjoying high

quality sound, please consult the following steps.

1. Unpack your GPO PR100 and remove the platter from its cardboard box.

2. Ensure that the elastic band around the interior rim of the platter is not twisted and

that it is flush with the platter's base.

3. Unpack the base unit and place it on a flat, stable surface

4. Holding the platter with the flat side down, place a finger through one of the larger

holes and stretch the elastic band around this finger (see image below left).

5. Holding the platter with the flat side up, place a finger through the same hole and

stretch the elastic band around this finger. This will help you attach it to the drive

shaft. Hold the band securely with your finger and thumb (see image below right).

6. Gently lower the platter onto the central spindle of the base unit, ensuring that the

elastic band is stretched over the drive shaft.

Table of Contents

Need help?

Do you have a question about the PR100 and is the answer not in the manual?

Page 1 GPO Retro – GPO PR100 Setup Guide Thanks for purchasing the GPO PR100. To correctly set up your unit and begin enjoying high quality sound, please consult the following steps. 1. Unpack your GPO PR100 and remove the platter from its cardboard box.
Page 2 7. Gently release the elastic band and remove your finger from the hole. The band should now be securely attached to the drive shaft. 8. Remove the ties securing the tone arm. 9. Attach the counterweight to the tone arm. This counterweight can be tightened or loosened to adjust the pressure on the stylus.