Table of Contents
Advertisement
USING YOUR FREEZER
Turning on the freezer
After setting the freezer in place, leveling (see page 4), plug
the power cord into the wall receptacle. The freezer should
start after plugging in. The temperature control is factory
preset to a mid range setting. Allow the freezer to run for 24
hours so the interior temperature stabilizes. If you wish to
adjust the interior temperature use a small bladed screw-
driver pushed through the right hand side of the grille to
turn the temperature control shaft. Turning it clockwise will
make the unit colder. Turning it counterclockwise will make
it warmer. Turning it counterclockwise until it stops will shut
off the compressor and fan motor.
Should you turn off your control, allow at least five (5)
minutes before restarting in order to give the motor control
time to automatically reset so that it can restart the motor.
Electrical power to your unit is controlled by the tempera-
ture control located in the front grille. (See Figure 9).
Temperature control lo-
Figure 9
cated behind right side of
air intake -exhaust grille.
Turn counterclockwise
until it stops to shut off
the compressor and fan.
7
Advertisement
Table of Contents
