Electrical Requirements ..........Handle Installation ............bols, Words, and Labels. Door Alignment ............Using your freezer ............Dimensions For MS15FA Solid Door ......Recommended Rough in Opening Dimensions ..For MS15FA Solid Door ..........Energy Saving Tips ............CAUTION- Hazards or unsafe practices which could Features ..............
UNPACKING YOUR FREEZER Warranty Registration Remove Packaging Your freezer has been packed for shipment with all parts It is important you send in your warranty registration card immediately after taking delivery of your freezer or you can that could be damaged by movement securely fastened. Cut the banding material at the bottom of the carton, unfold register online at www.agamarvel.com.
For this reason it is im- portant this area to not be obstructed and the grill openings kept clean. AGA MARVEL does not recommend the use of custom made grills as air flow may be restricted because of inadequate openings.
HANDLE INSTALLATION Handle Installation (Solid Door Models) 1. Remove the handle, (2) screws, and 5/32” allen wrench from the bag shipped inside the cabinet. 2. Locate handle opposite the hinges and secure in place using the (2) screws and the allen wrench. (See Figure •...
DOOR ALIGNMENT Door Alignment Procedure The door should be parallel to the sides and top of the freezer. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets on the top and bottom of the door and adjusting the door side to side.
USING YOUR FREEZER Turning on the freezer After setting the freezer in place, leveling (see page 4), plug the power cord into the wall receptacle. The freezer should start after plugging in. The temperature control is factory preset to a mid range setting. Allow the freezer to run for 24 hours so the interior temperature stabilizes.
(10.01 to 12.54cm) 21-25/32” (55.32cm) RECOMMENDED ROUGH IN OPENING DIMENSIONS, MS15FA SOLID DOOR Electrical Requirements: A 115 volt, 15 amp dedicated cir- cuit isrequired. A 3 prong grounded receptacle is required. Power outlet can be located in the back wall behind unit.
1. Do not install your appliance next to a hot appliance, Manual defrost. (ovens, glassware washers, etc.). heating air duct, or Probe Port (optional) for MS15FA other heat sources. The optional probe port is a hole from the inside to the out- 2.
CARE AND CLEANING Condenser Air Flow Defrosting Instructions MS15FA The condenser underneath the cabinet does not require 1. Disconnect the power cord and set the temperature frequent cleaning; however, satisfactory cooling de- control to the off position. (See page 7).
TROUBLESHOOTING YOUR FREEZER Before You Call for Service If the unit appears to be malfunctioning, read through this manual first. If the problem persists, check the trouble- Electrocution Hazard - Never attempt to repair or perform shooting guide below. Locate the problem in the guide and maintenance on the unit until the main electrical power has refer to the cause and its remedy before calling for service.
If Service is Required: • If the product is within the first year warranty period please contact your dealer or call AGA MARVEL Cus- tomer Service at 800.223.3900 for directions on how to obtain warranty coverage in your area. •...
If AGA MARVEL is unable to repair or replace the defective The warranties set forth herein are the only warranties product or component, AGA MARVEL shall issue a credit to...
Page 14
www.agamarvel.com 1260 E. VanDeinse St. Greenville MI 48838 800.223.3900 41014321-EN Rev C All specifications and product designs subject to change without notice. Such revisions do not 3/29/18 entitle the buyer to corresponding changes, improvements, additions, replacements or compensa- tion for previously purchased products.