Door Alignment Procedure
The door should be parallel to the sides and top of the
freezer. If alignment is necessary the door may be adjusted
by loosening the 2 screws which secure the hinge adapter
brackets on the top and bottom of the door and adjusting
the door side to side. Use a 5/32" allen wrench for this pro-
cedure. (See Figure 5 below). When finished aligning the
door, tighten the screws securely.
Hinge adapter bracket
located on the top and bot-
tom of the door.
Figure 5
DOOR ALIGNMENT
Remove top
hinge pin to re-
move the door.
9/32"
(7.1mm)
Door must be
parallel to top
and sides of
freezer.
NOTE
For the door to close properly, it is necessary to maintain
a minimum space of 9/32" (7mm) between the door and
cabinet flange (See Figure 5). This space can be adjusted
by adjusting the top and bottom hinge adapter brackets.
6