Preparation/Basic
2
Tap the camera lightly against your palm while holding it upside down
and then with the illustrated side facing down, and then wipe off the
water droplets with a soft, dry cloth.
• Repeat this step a few times if water is left in the microphone A or speaker B
hole.
If water is left in the microphone or speaker hole, weak or distorted audio may be
recorded and played back.
• Fasten the strap firmly to your wrist to avoid dropping the camera.
3
Dry the camera by standing it on a
dry cloth in a well ventilated shaded
area.
• This unit incorporates drain design,
draining water in gaps in the camera
[ON/OFF] button and zoom button etc.
• Do not dry the camera with hot air from
dryer or similar. Waterproof performance
will deteriorate due to deformation.
4
Confirm that there are no water droplets, open the side door, and wipe
off any water droplets or sand left inside using a soft, dry cloth.
• Water droplets may adhere to the card or battery when the side door is opened
without thoroughly drying. Also, water may accumulate in the gap around the
card/battery slot or the terminal connector. Be sure to wipe any water off with a
soft, dry cloth.
• The water droplets may seep into the camera when the side door is closed while it
is still wet, causing condensation or failure.
20
DVQX1500 (ENG)