Honeywell LYRIC W1 Quick Start Manual page 7

Reset
To reset the Wi-Fi, detector settings and to re-start the Bluetooth
pairing use one end of a paperclip to press and hold into the reset
hole for 5 seconds. The LED will blink blue.
Press and hold the paperclip into the reset hole for 15 seconds to
restore factory defaults. The LED will blink blue.
Status LED
The detector has an LED that gives device status.
LED
During installation
Blinking blue
Solid blue
Blinking green
Solid green
Solid red
During operation
Blinking red
Detector state
Powering up and connecting to Bluetooth.
Paired with Bluetooth.
Connecting to Wi-Fi network.
Has power, Wi-Fi connection, and is operating
normally.
Note: LED switches off after 5 minutes to
preserve battery life.
Failed to connect to Wi-Fi.
Detected a leak.
7