Advertisement
Table of Contents
V33459 Stanley
700 Amp Jump Starter
Always consult your product Instruction Manual before operation
1.
Turn off ignition and all accessories (lights, radio, A/C, etc.) and be
sure the vehicle is in park.
2.
Make sure the Jump-starter power switch is turned off.
3.
Connect the jump-starter's positive and negative clamps according to
the connection method specified in your vehicle's instruction manual.
4.
Please note if the red LED is lit and the audible alarm sounds the unit
is connected in reverse polarity and you must adjust your connection.
5.
When the clamps are properly connected, turn on the jump-starter's
power switch.
6.
Turn on the ignition and crank the engine in 5-6 second bursts until
the engine starts.
7.
Turn off the jump-starter power switch.
8.
Disconnect the jump-starter's positive and negative clamps according to the connection method
specified in your vehicle's instruction manual.
9.
Recharge your unit after each use and every 60 days to maintain the internal batteries life.
500 Watt Inverter
Always consult your product Instruction Manual before operation
1.
Plug in an AC device into one of the 120V AC outlets on the front of the unit.
2.
Turn on the inverter power switch on the unit's control panel.
3.
Do not exceed 500 watts.
4.
Check the battery status LEDs to monitor the units charge level.
5.
Recharge the unit when only one red LED illuminates when pressing the battery status button.
Recharging:
Always consult your product Instruction Manual before operation
1.
Lift the AC cover on the front of the unit near the handle and connect an extension cord to the built
in AC adapter.
2.
Plug the other end of the extension cord into a live 120V AC wall outlet.
3.
Recharge until all of the battery status LED's illuminate.
4.
Once fully charged, disconnect the extension cord.
©2015 Baccus Global LLC
PPRH7DS / PPRH7DS Quick Start Guide
FatMax
1400 Peak AMP Power Station with Digital Display
®
®
Advertisement
Table of Contents
Need help?
Do you have a question about the PPRH7DS and is the answer not in the manual?
Questions and answers
The battery will charge but looses power very quickly when trying to use. The unit is new and I bought it at the local goodwill store. I am interested in getting it fixed. Please advise me as how it can be done. The yellow tape on the handle has a service number on it.
If the Stanley PPRH7DS battery charges but loses power quickly during use, check for damaged parts and replace any that are damaged. The battery may be deteriorating and no longer holding a charge properly. If so, it may need to be replaced. Do not attempt to operate the unit if critical components are damaged.
This answer is automatically generated