Table of Contents
Advertisement
Quick Links
PREPARATION
INSTALLING BATTERIES
Your measurer requires 9V battery (not supplied) for power. For the best
performance and life, we recommend alkaline battery.
Follow these steps to install a battery.
1. Slide the battery compartment cover in the direction of the arrow to remove it.
2. Snap the battery in the compartment, as indicated by the polarity symbols (+
and - ) marked inside.
3. Replace the cover.
When LOW BATT appears or the measurer stops operating properly, replace the
battery.
Caution: If you do not plan to use the measurer for a month or more, remove the
battery. Batteries can leak chemicals that can destroy electronic parts.
STABILIZING THE MEASURER
Your measurer is sensitive to changes in temperature and humidity. Before you
use the measurer, wait about 15~30 minutes for it to stabilize to the current
room's temperature.
OPERATION
TURNING THE MEASURER ON/OFF
To turn on the measurer, press MEASURE. The measurer turns itself off if no key
is pressed within about 4 minutes or press MEASURE for 3 seconds to turn it off.
TAKING A MEASUREMENT
1. Press MEASURE to turn on the unit. The measurer beeps then the distance
between the measurer and the point you measured appears.
2. Hold the bottom of the measurer flat against a wall, about halfway between the
floor and ceiling. Be sure there is a clear path to the point you want to measure
and that your head or hands do not block the front of the measurer.
3. Repeatedly press FEET/METER until FEET appears (to measure in feet ) or
until METER appears (to measure in meter).
Notes:
Ultrasonic Distance Measurer
OWNER'S MANUAL
1
Advertisement
Table of Contents
Related Manuals for Veto E5020503
Summary of Contents for Veto E5020503
-
Page 1: Installing Batteries
Ultrasonic Distance Measurer OWNER’S MANUAL PREPARATION INSTALLING BATTERIES Your measurer requires 9V battery (not supplied) for power. For the best performance and life, we recommend alkaline battery. Follow these steps to install a battery. 1. Slide the battery compartment cover in the direction of the arrow to remove it. 2. - Page 2 The measurement appears for about 4 minutes (or longer if you press another key). ERROR might appear if you try to measure a distance shorter than the set range of 2 feet (0.61m) or longer than 60 feet (18.288 meters). Measuring Tips Some types of curtains and blinds can absorb sound waves, causing ...
- Page 3 4. To display a measurement stored in a memory location, press that memory key (M1,M2 or M3). The measurement stored in that memory location appears. To delete a measurement stored in a memory location, simply store a new one in its place.
- Page 4 SPECIFICATIONS Power Source……………………………………………..1x9V Unit of measurement…………………………….Feet or Meters Accuracy………………………………………….0.5%±1digit (8~60ft) 1%±1digit (2~8ft) Working Frequency……………………………………….40kHz Working Temp…………………32°to 109.4°F(0°to 43°C) Range…………………………………2 to 60ft (0.61 to 18.288m) Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice. Caution: The laser emitted from the unit is visible laser of 650nm ...
Need help?
Do you have a question about the E5020503 and is the answer not in the manual?
Questions and answers