Table of Contents
Advertisement
3.1.3 Removing the front panel assembly (See Figure 5, Figure 6 )
• Prior to performing the following procedure, remove the top
cover/mechanism assembly
(1) Disconnect the card wire from connector
main board.
(2) Disconnect the flat wire from connector
board.
(3) Remove the one screw D attaching the MIC bracket.
(4) Hook b and c are removed respectively, and the front panel
assembly is removed.
3.1.4 Removing the rear panel (See Figure 7 )
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the seven screws E attaching the rear panel.
(2) Disconnect the power cord from connector
power board
3.1.5 Removing the main board and power board. (See Figure 8)
• Prior to performing the following procedure, remove the top
cover/rear panel.
(1) Remove the two screws F attaching the main board.
(2) Disconnect the card wire from connector CN201,
CN202,CN502,
CN101
(3) Disconnect the flat wire from connector
board.
(4) Disconnect the flat wire from connector
er board.
(5) Remove the three screws G attaching the power board.
CN502
on the
CN702
on the main
P901
on the
on the main board.
CN702
on the main
CN901
on the pow-
D
Front panel assembly
Fig.5
Hook c
Hook c
Front panel
assembly
Hook b
Fig.6
Power board
P901
Rear panel
E
Fig.7
Power board
CN202
G
G
CN901 G
Fig.8
CN502
Main board
CN702
Hook b
Hook c
E
CN502
F
CN101
F
CN702
Main board
CN201
(No.YD034)1-9
Advertisement
Table of Contents
