Diamond SupraExpress 56e Manual page 76

S8
S9
S10 Delay from Lost Carrier to Hang Up
S11 DTMF Tone Duration/Spacing
S12 Escape Prompt Delay (EPD)
S24 Sleep Inactivity Timer
S25 Delay to DTR
S26 RTS/CTS Delay
S29 Flash Dial Modifier Time
S30 Disconnect Inactivity Time
76
Pause Time for Comma Dial Command Modifier
(range = 2-255; default = 2; units = second)
The length of the pause caused by a comma in the D dial command.
Time to Wait Before Recognizing Carrier
(range = 1-255; default = 12; units = 1/10 seconds)
The length of time after a carrier first appears that the modem waits to recognize carrier and
turn on DCD. This delay allows the modem to ignore spurious signals that are the same
frequency as the carrier. Higher S9 values reduce the chance of a false carrier being detected.
(range = 1-255; default = 14; units = 1/10 second)
The time your modem waits for a carrier to return before disconnecting. A long enough time
allows the remote modem's signal to momentarily disappear without making your modem
disconnect. S10=255 causes your modem to assume carrier is always present.
(range = 60-102; default = 95; units = 1/100 second)
The spacing between and duration of DTMF (dial) tones during tone calling. The spacing
between tones is equal to the duration of each tone. The default depends on your modem
model.
(range = Ø-255; Ø disables timer; default = 50;
units = 1/50 second). The delay required before and after entering the escape code.
(range = Ø-255; default/disable*=Ø)
The number of seconds before the modem enters sleep mode without either DTE or phone line
activity. (On external models the DTR line must be low (off) to allow the modem to enter
SLEEP mode. *Non-display models default to S24+30. Serial PnP units will NOT sleep if Serial
PnP mode is enabled (S193.Ø=1 default).
(range = Ø-255; default = 5; units = 1/100 second)
The shortest length of a DTR change the modem recognizes. If AT&D2, the modem will not
hang up if the transition is less than S25.
(range = Ø-255; default = 1; units = 1/100 second
Synch mode only.
(range=Ø-255; default=70; units=10 ms; disable=Ø)
Sets the length of time in units of 10 ms, that the modem will go on-hook when it encounters
the flash(!) dial modifier in the dial string. The time is a country code dependent parameter.
(range = Ø-255; default = Ø; unit 10 second;disable =Ø)