Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Senco RoofPro 445XP
Summary of Contents for Senco RoofPro 445XP
- Page 1 RoofPro 445XP Coil Roofing Nailer Operating Instructions...
-
Page 2: Table Of Contents
tAblE oF CoNtENts ’ ......2 mployEr EsponsibilitiEs ........3 afEty arnings EmployEr’s rEspoNsIbIlItIEs ............ 7 Employer must enforce compliance ..........9 aintEnancE with the safety warnings and all other ........10 instructions which accompany this roUblEshooting tool as shipped from the manufacturer.......... -
Page 3: Safety Warnings
sAFEty WArNINgs Warning! Read and understand tool labels and manual. Failure to follow warnings could result in DEATH or SERIOUS INJURY. save these Instructions Use safety equipment. Always wear ANSI Z87.1 safety glasses with permanently attached side shields. Dust mask, non-skid safety shoes, hard hat, or hear- ing protection must be used for appropriate conditions. - Page 4 sAFEty WArNINgs Drive fasteners into work surface only; never into materials too hard to penetrate. Do not drive fasteners on top of other fasteners or with the tool at too steep of an angle; the fasteners can ricochet and hurt someone When using tool, care should be taken due to possibility of tool recoil after a fastener is driven.
- Page 5 Tools are dangerous in the hands of untrained users. Use only parts, fasteners, and ac- cessories recommended or sold by SENCO. Do not modify tool without authorization from SENCO. Use only clean, dry, regulated compressed air at recommended pressure.
- Page 6 (5) NEVER point tool at yourself or others in work area. (6) NEVER use oxygen or other bottled gases. Explosion may occur. obtain a new label. (7) MAX AIR PRESS. 120 PSI (8.3 BAR) Always place yourself in a firmly balanced position when using or handling the tool. For information on the “SENCO Safety First Program,” contact your SENCO representative.
-
Page 7: Tool Use
tool usE Read section titled “Safety Warn- ings,” before using tool. to Adjust magazine: Squeeze the gate latch and lift open gate. Open Magazine. Lift and shift nail disk to accept different length nails. Note: Reference points on magazine coincide with nail lengths. - Page 8 tool usE read the “Customer satisfaction and safety reminder” (Cssr) in the tool and fastener boxes for safety information regarding the Contact-Actuation and sequential trigger modes. under certain conditions, the sequential trigger mode may reduce the possibility of injury to you or to others working with you.
-
Page 9: Maintenance
(safety element) and trigger. Do not use tool if workpiece contact (safety element) or trigger sticks or binds. Squirt Senco pneumatic oil (5 to 10 drops) into the air inlet twice daily (depending on frequency of tool use). Other oils may dam- age O-rings and other tool parts. -
Page 10: Troubleshooting
Clean tool / Tighten screws or install Repair Kit YK0865. symptom Other problems. solutIoN Contact SENCO. ACCEssorIEs SENCO offers a full line of accessories for your SENCO tools, including: Air Compressors Hose Couplers Fittings Safety Glasses Pressure Gauges... -
Page 11: Echnical S Pecifications
tECHNICAl spECIFICAtIoNs Min to max operating pressure 70-120 psi Air Consumption (60 cycles per minute) 3.86 scfm Air Inlet 1/4 in. NPT Minimum Speed (cycles per second) Weight 5.21 lbs. Nails per Magazine Capacity Nail Lengths 3/4 in. to 1-3/4 in. Nail Shank .120 Tool size: Height...