Secutron MMX-2009-12NDS User Manual page 25

Front Panel Menu Operation
Device/Circuit Bypass
Use this option if you want to bypass or unbypass a device or circuit from the panel. Usually this is done when you
need to add, remove, repair, or investigate a device or circuit.
To unbypass the device or circuit, follow the same procedure for device/circuit bypass.
Step 1: Select Device/Circuit
- Bypass Menu -
1 Device /Circuit
2 Relay Disc
3 Input Zone
Step 2: Enter your passcode
Enter passcode for
level 1 or higher:
Step 3: Select a device
- Select Device -
Node: 0
Loop: 0
Device: 0 0 0
Step 4: Bypass the device/circuit
Strobe Output
Floor 2
L0 000 not
bypassed. Bypass? Y
At this point the display will vary, depending on your choice:
• If you selected "yes", the system will display the message "Device/Circuit bypassed (unbypassed), then it will
return to the Bypass Menu.
• If you selected "no", the system will display the message "Operation cancelled", then it will return to the
Bypass Menu.
22
Press when the cursor is flashing beside
"Device/Circuit" to select a device.
Enter your passcode. See page 10 for instructions on
entering passcodes.
1. Use and
device number.
2. Enter the node number, then press
3. Enter the loop number, then press
4. Enter the device number, pressing
as needed to move left and right.
5. Press to continue.
1. The systems now asks you whether or not you would
like to bypass or unbypass the device. Use
to select "yes" or "no".
2. Press to continue.
to select the node, loop and
.
.
and
and