Table of Contents
Advertisement
Alignment and Adjustments
•
After Factory Auto convergence is complete, make sure that the cursor flickers for about
`
1 second on the center and then it is saved.
•
OSD shows error.
•
When any error happens, be sure to re-do Factory Auto Convergence.
•
When Convergence Adjustment is not normally done or the convergence center is
misaligned with the sensing point, any adjustment error happens. Therefore, be sure to use
a screen jig to correctly adjust during troubleshooting.
2. After the Convergence Adjustments are completde, press the
3. DTV Convergence adjustment must be done same as the above Normal Mode Convergence Adjustment
(Use a 16 : 9 screen jig for DTV)
When Convergence Adjustment is not normally done or the convergence center is
misaligned with the sensing point, any adjustment error happens. Therefore, be sure to
use a screen jig to correctly adjust during troubeshooting.
I Changes when applying Almighty-Cg, Module (How to extract the basic Cg Data)
Inch
Model Name
47"
52"
55"
HCN5529W
65"
2-24
CN479W
HCN529W
HCN559W
HCN659W
Data
Screen Display
5- 473
5- 521
5- 553
5- 653
key to exit.
Samsung Electronics
Advertisement
Table of Contents
