Table of Contents
Advertisement
2-5 Beam alignment Adjustments
1. Select the "STANDARD" video mode.
2. Warm up the set at least for 10 minutes.
3. Enter the Convergence mode by pressing the remote control buttons in the following sequence
:
4. Set the Beam Alignment Adjustment CY to Zero magnetic field area.
(Creation of CPM Zero Magnet)
5
Press the
button on the remote control, and a vibrating dot-pattern appears.
6. Adjust the Focus-pack VR for defocusing.
G-FOCUS
7. Mute the other patterns (R/B) other than G-PATTERN.
(Use
/
8. Adjust the 2, 4 polarities of VM-COIL as shown in figure below.
9. Adjust the G-Focus until any light around the core disappears.
G-FOCUS
G-FOCUS
(Varying G-Focus Pack)
G-FOCUS
(When VM 2-Pole Adjustment is completed)
10. Adjust G-Focus so that the surrounding flash can disappear from the spot.
11. After G-Focus adjustments are complete, adjust R-Focus as above procedures.
12. The B-CRT adjustments can be omitted because the variance of beam focus is small.
(Only Vm-coil is mounted.)
13. Adjust the Focus-pack VR for fine focusing.
14. Press the
button on the remote control, and the mode changes to the Convergence Adjustment
mode.
15. Press the
button on the remote control to return to normal viewing.
Samsung Electronics
(Creation of the 2-pole/4-pole zero magnets)
CORE
buttons on the remote control.)
CORE
CORE
Varying the 2-pole of VM
CORE
Varying the 4-pole of VM
(Positioning the Core in the Center)
(Adjust until the light around
the core becomes a circle)
Alignment and Adjustments
2-13
Advertisement
Table of Contents
