3D Flight Piper Super Cub Manual page 13

Glue Ailerons and Flaps Together
Glue together the ailerons and flaps, then attach them to the airframe using CA hinge material in
the designed in slots. CA hinge strips cut about .2in by .6in should work well for this.
Install Servos for Ailerons and Flaps
Glue in the servos for the ailerons and flaps and add control rods (cut the 1mm wire and add z
bends). The leads can be fed through the paths designed into the wing. Each aileron servo will
most likely need an extension and the flaps should have a Y extension. It's recommended that
you clip the appendages off the sides of the servos to fit them in the receiving slots in the wing.
You can use the clearance between the servos and the recieving slots for micro adjustment.
Glue Fuselage Segments Together
Apply CA glue along segments and apply accelerator, glue should dry within seconds making
assembly easy. Repeat until all segments of the fuselage and horizontal stabilizer are glued
together. The two halves of the horizontal stabilizer are glued together using their connectors
(shaped like trapezoidal prisms) and glued to the bottom of the vertical stabilizer. Dont apply
accelerator until all segments are aligned straight. Fuselage1 is screwed to fuselage2 to allow
motor installation and access to the front of the plane so do not glue.
12