Table of Contents
Advertisement
How to use the receiver of Knight TR-331RX
5. Please confirm whether the channel is corresponded with the transmitter or not after
the setting of Knight TR-331RX channel.
Turn on the LCD backlight of Knight TR-331RX
Turn on the Knight TR-331RX power, it is available to open the LCD's backlight through
press [
], the backlight will turn off in 4s automatically when no action on [
SET
En
and [
].
SET
Connect Knight TR-331RX with the flash
1 Please make sure the flash's power is turned off before install the flash into
.
Knight TR-331RX, confirm the power of Knight TR-331RX is turned on, Set the
function mode and channel.
2. The receiver does not support the flash hot-drawing and hot-plug in the installation
Lock the flash to the right position, please lock the rod clockwise by rotation until to
the signs of installation mount.
24
or removal of flash, the flash must be inserted or pulled out in the off state.
3. Insert the flash and mount into the hot shoe of Knight TR-331RX.
4. Rotate the flash bar to the locked position.
Remove the flash from Knight TR-331RX
1 Please make sure the flash's power is off before remove the flash.
.
]
POWER
2. Follow the figure to rotate the flash lock rod 90 degrees to the left.
3. Pull out the flash from the hot shoe mount of Knight TR-331RX.
If the flash can't be pulled out from the hot shoe:
Installation lock of flash was still inserted on Knight TR-331RX
hot shoe, rotate 90 degrees of flash lock rod to the left again,
and gently pull out the flash from the TR-331RX hot shoe, do
not forcibly pull it.
How to use the receiver of Knight TR-331RX
1
2 5
Advertisement
Table of Contents
