Rosen DS-TY0820 Installation Manual page 6

10 – Pre-Delivery Test
You will need to fully test the system to ensure it is working and connected to the vehicle properly. The following steps will
guide you through this process.
Step 1: Initial Test
a. Reconnect the vehicle battery if needed
b. Start the vehicle (ensure that it is safe to do so)
c. Perform the following steps on the Multi-Media Systems to ensure proper operation:
•
Turn the unit ON
•
Select all available sources
• Test the Steering Wheel Controls
•
Test the Backup Sensors
•
Test the Navigation
•
Eject the test disc
• Turn the vehicle off and wait for the unit to turn off
d. If the system does not function properly, reset the system by pressing and holding the reset
button located near the eject button
Step 3: Pre-Delivery Preparation
a. Start the vehicle (ensure that it is safe to do so)
b. Perform the following steps
• Calibrate the Navigation Touch Screen, if not already performed
•
Calibrate the Primary Touch Screen, if not already performed
• Retest the Radio and general audio performance of the system
•
Remove the protective films and clean the unit as needed
c. Place the Owner's Information package in the glove compartment
Service and Optional Parts List
Part Number Description
DP-TY0821 Quick Reference Guide
DP-TY0824 Installation Guide
DP-1001 Manual, Owner's
DP-1003 Manual, Navigation
DP-1004 Remote Control
DP-1023 Pin, Stylus
DP-1020 Card, SD without maps
DP-1022 Antenna, GPS
DP-1025 Tuner, XMD1000 Kit
DP-1035 Camera, Cylinder W/Mount
DP-1036 Camera, License Plate
Rosen Entertainment Systems
Installation Guide
Installation Guide Toyota Corolla
o Select the Radio and test several stations
o
Select the DVD and test playback of a disc
o Select the iPod and test music playback
o Select the XM tuner if equipped, and wait for XM Preview to start
o If the vehicle is equipped, test all steering wheel controls
o
If installed, test the sensors by placing a stationary object behind the vehicle (never test
the sensors by backing the vehicle into an object)
o Repeat this for each of the sensors
o Select the Navigation and wait for the satellites to be located
o Confirm the location reported is your current location
Part Number Description
DP-TY0822 Harness, Main Interconnect
DP-TY0823 Harness, Steering Wheel Cntls
DP-1008 Harness, AUX Out
DP-1009 Harness, AUX IN
DP-1010 Harness, Sensors/Camera
DP-1011 Harness, Dolby 5.1/Amp
DP-1013 Harness, iPod/Interface Box
DP-1014 Harness, XM Radio Interface
DP-1015 Harness, iPod Replacement
DP-1007 Harness, USB Adaptor
Copyright 2007 all rights reserved
DP-TY0824 Rev A
Page 6