Table of Contents
Advertisement
7 – Connect and Install the Rosen Unit
You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you
through this process.
Note: Connect BRAKE WIRE (blue w/ white) to Emergency brake switch wire (ground when E-brake is
engaged). This insures video is disabled while vehicle is in motion.
Note: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen unit is
installed.
Note: For vehicles with Dual Diversity Antenna, connect the White Antenna lead only, and protect the second
antenna lead from damage. For improved Radio performance, use an aftermarket dual diversity antenna adaptor.
Step 1: Remove transport
screws
Insure that the video disable connection is connected as intended and working as designed!!!
Be sure to fully engage all connectors and prevent them from causing vibrating noises
8 – Re-Install Interior Trim Components
You will need to re-install the interior trim components. The following steps will help guide you through this process.
Note: When Installing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.
Step 1: Attach the Electrical
Connection and install the
Vent Trim
Use Caution. See the OEM Service Manual for additional information on the installation process
Rosen Entertainment Systems
Installation Guide
Installation Guide Toyota Corolla
Step 2: Connect the GPS,
Steering Wheel Control
and Power Connections
Step 2: Install the Lower Trim
Components
Step 3: Connect the iPod and
optional XM, Camera and
Backing Sensors
Step 3: Install the Upper Trim
Component
Step 4: Prepare the Vehicle side
connection harnesses
Step 4: Verify unit operation
Copyright 2007 all rights reserved
DP-TY0824 Rev A
Page 4
Advertisement
Table of Contents
