Advertisement
NOTE: Learning Mode lasts for only 5 seconds; if no
signal is received from a remote handset during this
time then the adapter will automatically exit learning
mode without pairing the device.
Unpairing Remotes and clearing the Switch
memory
Removing single device:
1. Remove the plug adaptor from the wall socket and
after 5 seconds replace it.
2. Once plugged into the wall the adaptor will enter
LEARNING MODE for a duration of 5 seconds, this will
be illustrated by the red LED ashing on and o .
3. Whilst the adaptor is in leaning mode, on the
Remote press the 'OFF' buttons of the paired channel
that needs to be unpaired; the LED on the adaptor will
stop blinking and any lamp plugged in and turned on
will ash twice to indicate that it is un-paired.
Advertisement
