TELUS Optik TV Programming Manual

Programming devices to Optik TV

Programming your TV

Remote Control

Before you start to program your remote control, make sure your TV is switched on.
1 Tap the button until the red TV light on your remote flashes, as shown in
the picture on the right.
2 Press and hold the
3 Refer to the table on the right. Enter the code for your TV brand.
The light will flash twice.
* Selecting "Other" will search for all other TV brands and may take up to 15 minutes to generate codes.
4
Press and hold the
finger from the button.
5
Press . The red TV light will flash twice.
6
Press the button again to switch your TV back on.
7
Tap the button until the green OPTIK light is illuminated at the top
of your remote.
That's all there is to it. Now, you can turn your TV and digital box on and off
simultaneously by pressing the

DVD, BluRay and Audio Auxiliary Devices

To learn how to program your remote to control these devices,
please visit telus.com/programtvdevices.

Quick tips

1 Back/Exit:     a. Tap to go back. b. Press and hold to exit.
2 If you're using Xbox 360
to control it. To control your Xbox 360
Congratulations – you're done!

Troubleshooting:

If the programming does not work properly,
please refer to the FAQ's at telus.com/remotefaq.
© 2012 TELUS. 08/12
button for 3 seconds, until the TV light flashes twice.
button. When your TV switches off, remove your
button on your remote.
as a set top box, your remote has been pre-programmed
®
, make sure you are in AUX mode.
®
TM
Mode & Power
Buttons
Codes for
TV Brand
Funai 11
Insignia 21
LG 15
Panasonic 13
Philips 19
RCA 20
Samsung 18
Sanyo 12
Sharp 14
Sony 17
Toshiba 16
Vizio 10
Other* 29
OK Button