Table of Contents
Advertisement
3.2.2
Local site transportation
When you transport the UPS equipment after it has been off-loaded (for example, for storage or moving to the installation
location) please observe the following precautions.
CAUTION: Local transportation:
•
When moving the UPS cabinet using a forklift or pallet jack, insert the lifting equipment forks into the
front and rear shipping brackets to lift the cabinet securely and prevent it from toppling over.
•
Do not at any time tilt the cabinet by more than 10° from vertical.
WARNING: Potential dangers:
•
If the equipment cabinet is tilted by more than 10° it could cause internal damage. If tilting occurs do
not connect the UPS to the mains electrical supply.
•
The weight cabinet can cause serious personal injury and/or structural damage to the surrounding
area if dropped in transit. Always take extreme care when moving the equipment.
3.2.3
Storage
If you plan to store the UPS prior to its installation it should be kept it in a clean, dry environment with a temperature
between -25°C to +70°C and RH <90%, and preferably in its shipping packaging. If the storage period is likely to exceed
seven days the packaging should be removed and the UPS inspected for internal/external shipping damage before it is
placed into storage. If there is no apparent damage you should refit the packaging or cover the UPS with a dust-cover to
prevent the ingress of dust and dirt.
As standard, the UPS batteries can be housed within the UPS cabinet (40kVA and 60kVA models) or within an external
battery cabinet or rack-mounted (80kVA, 120KW, 200kVA models). In the case of internally-mounted batteries, the
batteries can be shipped already fitted within a cabinet; alternatively, batteries intended for external rack-mounting will be
shipped in a separate package. which should be stored under the environmental conditions stipulated above.
3.2.4
Unpacking
WARNING: The UPS system, the battery cabinet (optional) and the batteries are heavy and may tip during
transportation causing serious injury if the unpacking instructions are not followed closely.
If the shipment is received in good order (i.e. the 'tip & tell' "FRAGILE" and "ARROW" indicators on the packing container
are intact) then unpack the UPS as follows:
1.
If the cabinet is shipped inside a wooden case, remove the screws at the base and sides of the case then carefully
remove the case from the package.
2.
Cut the wrappers and remove the packing container by pulling it upwards.
3.
Remove the plastic sheeting covering the UPS.
4.
Remove the UPS from the pallet.
5.
Retain the packaging materials for future shipment of the UPS.
6.
Examine the UPS for any sign of damage and notify your supplier immediately if damage is apparent.
7.
Open the cabinet door and verify that the UPS rating specifications on the nameplate located inside the door match
the order specification.
8.
Remove any accessories packages that are shipped inside the cabinet.
9.
Remove any internal protective packaging.
10. Ensure that all the UPS modules are securely fitted in their compartments. Ensure that a protection cover is fitted to
the front of any empty UPS compartments.
TS_616_03 PW8000DPA ST S2 User Manual 4/4/18
3: Installation
31
Advertisement
Table of Contents
