Roland GI-20 Owner's Manual page 20

Chapter 2 Creating Your Own Settings (Patches)
1. Turn the PARAMETER knob to "ASSIGN."
fig.02-11
2. Press [SELECT] to select the parameter whose settings
you want to change.
The display indicators light up as shown below
according to the parameter being set.
fig.02-12
Lit
Lit
L i t
L i t
L i t
3. Press [PATCH/VALUE] to change the value.
* For more on the settings values that can be selected, refer to
the following section "Functions That Can Be Selected With
Assign (ASSIGN)."
4. If you want to save the settings, carry out the Write
procedure (p. 26).
* If you do not want to save the settings, turn the
PARAMETER knob to return to "PLAY MODE."
5. When you have finished making the settings, turn the
PARAMETER knob to return to "PLAY MODE."
20
When the expression pedal is selected
When FOOT SWITCH 1 is selected
When FOOT SWITCH 2 is selected
When GK VOLUME is selected
When the S1/S2 switch is selected
Functions That Can Be Selected With
ASSIGN
The following describes the functions that can be assigned to
the controllers.
Controller function
Expression Pedal CC#1–31, 64–95, Pitch Bend 1–6,
Vibrato 1–4
Foot Switch 1/2 CC#1–31, 64–95, Patch Up, Patch Down,
Octave Up, Octave Down, GR Hold1–3,
Glide Up 1–8, Glide Down 1–8,
Vibrato 1–4
GK Volume CC#1–31, 64–95
S1/S2 Switch Patch Up/Down, Octave Up/Down
* When "POLY" is selected as the transmission mode, the Pitch
Bend/Glide and Vibrato function as follows.
When BEND RANGE (p. 23) is set to anything other than
Chromatic, Pitch Bend/Glide changes in semitone steps when
chords are played, and Vibrato does not function. These
function normally when you play notes individually.
When patches are switched, no signal is transmitted to
restore the Control Change value transmitted with the
previous patch. Therefore, if the same assign settings are
used for both of the patches prior to and following the
switch, the status of the controllers is carried over. However,
if the assign settings are different for the patch you are
switching to, you cannot restore the value for the Control
Change transmitted with the earlier patch, so you will need
to be aware of the following.
(Example)
The volume of a patch with CC 7 (Volume) assigned to the
expression pedal is lowered to the minimum level. After this,
if you switch to a patch with a different assign setting, since
CC 7 (Volume) is not controlled in that patch, no sound is
output, even when you press the expression pedal.
1–31, 64–95 (MIDI Control Change CC#1–31, CC#64–95)
Transmits Control Change messages
(#1–#31, #64–#95) from MIDI OUT.
For more on the functions controlled
with Control Change messages, refer
to the "MIDI Implementation" (p. 40)
(Ex.) CC 1
and owner's manual for the sound
module you are using.
Pu: Patch Up
The patch number increases each time
the switch is pressed.