Mini HARDTOP 2 DOOR 2018 Owner's Manual page 121

is switched off, refer to page 104, while
selector lever position R, D or M/S is en-
gaged.
– If the driver's safety belt is unbuckled,
the driver's door is opened, and the
brake pedal is not pressed while the ve-
hicle is stationary and selector lever po-
sition D, M/S or R is engaged.
– After the ignition has been switched off
while selector lever position N is en-
gaged.
Engaging selector lever positions:
with a latching selector lever
General information
To prevent the vehicle from creeping after
you select a drive mode, maintain pressure
on the brake pedal until you are ready to
start.
Functional requirements
The selector lever can only be taken out of
selector lever position P if the ignition is on
or the engine is running.
Engaging selector lever position D, N,
R, or P
With the vehicle stationary, depress the
brake pedal before shifting out of selector
lever position P or N; otherwise, the shift
block will not be deactivated and the shift
command will not be executed.
A selector lever lock prevents the following
faulty operation:
– Unintentional shifting into selector
lever position P or R.
Online Edition for Part no. 01402723718 - VI/18
Driving
– Unintentional shifting from selector
lever position P into another selector
lever position.
1. To release the selector lever lock: with
the brake pedal depressed, press the
button on the front of the selector lever.
2. Move the selector lever into the desired
position.
Engaging selector lever positions:
with a tap-operated selector lever
General information
To prevent the vehicle from creeping after
you select a drive mode, maintain pressure
on the brake pedal until you are ready to
start.
Functional requirements
Only when the brake pedal is depressed is it
possible to change from selector lever posi-
tion P to another selector lever position.
Depending on the transmission version, the
engine may have to be running too.
CONTROLS
121