Rear Panel - Roland Musical Instrument Amplifier Owner's Manual

Roland musical instrument amplifier user manual
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Panel Descriptions

Rear Panel

Set the switches as shown below.
Set the switches as shown below.
B
B
Start/Stop
Start/Stop
BOSS FS-6
BOSS FS-6
Set the polarity
Set the polarity
switch as shown
switch as shown
White
White
below.
below.
Start/Stop
Start/Stop
Cord Hook
1.
Hook the AC adaptor cord here.
→ Connecting the AC Adaptor (p. 5)
2.
AC Adaptor Jack
Connect the included AC adaptor to this jack.
Use only the AC adaptor included with the MICRO CUBE BASS RX. Use
of other AC adaptors may damage the amp or result in other problems.
→ Connecting the AC Adaptor (p. 5)
FOOT SW (Footswitch) Jack
3.
If you connect a footswitch (the optional BOSS FS-5U or FS-6), you can
operate the RHYTHM GUIDE function (START/STOP and TAP TEMPO).
4.
REC OUT/PHONES Jack
Connect stereo headphones or a recording device to this jack.
It supports stereo output.
* No sound is played through the unit's speaker while the
REC OUT/PHONES jack is in use.
5.
AUX IN Jack
You can connect devices such as a CD player, digital audio player or
electronic musical instrument, and have it play along with your bass guitar.
Offers two types of jacks for external input; a mono 1/4" phone jack
and a stereo-mini jack. Use the appropriate cable (optional) for the
device that you are connecting.
* Determine the volume level by adjusting the volume control of
the connected device.
8
A
A
White
White
(L ch)
(L ch)
Tap Tempo
Tap Tempo
PCS-31
PCS-31
Red
Red
BOSS FS-5U
BOSS FS-5U
Tap Tempo
Tap Tempo
Mixer
Mixer
Stereo Headphones
Stereo Headphones
Red
Red
(R ch)
(R ch)
PCS-31
PCS-31
Ground Terminal
6.
Depending on the circumstances of a particular setup, you may
experience a discomforting sensation, or perceive that the surface feels
gritty to the touch when you touch this device, microphones connected
to it, or the metal portions of other objects, such as guitars. This is due to
an infinitesimal electrical charge, which is absolutely harmless. However,
if you are concerned about this, connect the ground terminal with an
external ground. When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you are unsure
of the connection method, contact the nearest Roland Service Center,
or an authorized Roland distributor, as listed on the "Information" page.
Unsuitable places for connection
Water pipes (may result in electrical shock)
Gas pipes (may result in fire or explosion)
Telephone-line ground or lightning rod (may be dangerous
in the event of lightning)
7.
Battery Compartment
Insert 6 AA batteries. Use only alkaline batteries (LR6).
You cannot use any other type of battery.
→ Inserting Batteries (p. 5)
8.
Security Slot (
You can connect commercially available anti-theft security cables
and other security devices to the unit.
http://www.kensington.com/
Recorder
Recorder
Standard
Standard
Stereo Cable
Stereo Cable
Stereo Mini
Stereo Mini
Cable
Cable
Electronic Musical
Electronic Musical
Instruments, etc.
Instruments, etc.
)
Digital
Digital
Audio
Audio
Player
Player
Standard Mono
Standard Mono
Cable
Cable

Advertisement

Table of Contents
loading

This manual is also suitable for:

Micro cube bass rx

Table of Contents