Roland Acoustic Chorus AC-33 Owner's Manual page 9

Jack Panel
10 11
11 11 11 11 11 11
10
DC IN (AC Adaptor)
Jack
Connect the included AC
adaptor here (p. 4).
You must use only the AC
adaptor that is supplied
with the AC-33.
12
LINE OUT Jacks
R L
NOTE
When connection cables with resistors are used, the volume level of equipment connected to the inputs (GUITAR CHANNEL, MIC/LINE CHANNEL, AUX
IN,) may be low. If this happens, use connection cables that do not contain resistors.
NOTE
You may connect to both types of AUX IN jacks simultaneously, but this may cause the volume to be lower compared to using one type exclusively.
12
FOOT SW (Foot Switch) Jack
If foot switches are connected, you'll be able to control the Looper function or turn eff ects on/off using your foot.
You'll need momentary-type foot switches (BOSS FS-5U or FS-6; sold separately) and a connection cables (Roland PCS-31 or PCS-33;
sold separately).
Set the polarity switch of the foot switches as shown in the illustration.
Polarity switch
PCS-31
Red
(RING)
BOSS FS-5U
BOSS FS-5U
You can connect your mixer or
recorder here. Connect to the L/MONO
jack if you're outputting in mono.
The [MASTER] knob does not aff ect the
output from the LINE OUT jacks.
13
PCS-33
White
(TIP)
BOSS FS-6
13
AUX IN Jack/[LEVEL] knob
Here you can connect a CD player or portable audio
player.
Use the [LEVEL] knob to adjust the volume.
The eff ect is not applied to AUX IN jack.
L
R
14
Security Slot ( )
http://www.kensington.com/
14
Set the switches as follows
B A
BOSS FS-6
9