Alarm Codes Table - Electrolux EDW 503 Service Manual

Service Code Reason
Family
(Platform specific)
00 Zero cross or low voltage
10 Fill_D – static fill level
Fill – re-fill level
20 Draining problem
30 Aqua Control
Analogue pressure
40
-
no signal
Pressure Sensor Calibration
-
signal too noisy
Analogue pressure
-
signal too high
Analogue pressure
-
signal too low
Pressure Sensor Calibration
-
signal too low
Pressure Sensor Calibration
50 AC Wash pump tsc
WP BLDC over current HW
WP BLDC over current SW
WP BLDC motor not following
BLDC under voltage
BLDC over voltage
(PB100 only) DP ADC fault
(DIVA2 only)
DCLink plausibility error
Technical Support – A.R.
Alarm Codes
Type User visible User
indication
stop No Nothing
ack Yes i10
ack Yes i11
ack Yes i20
stop Yes i30
abort Yes i40
warning No Nothing
abort Yes i43
abort Yes i44
Nothing
warning No
warning No Nothing
abort Yes i51
abort Yes i52
abort Yes i53
abort Yes i54
i55
stop Yes
stop Yes i56
abort Yes i57
Please OBSERVE that i57 has different meaning depending on platform
i57
abort Yes
599 79 76 - 53 REV 1.0
failure Action in case of failure happens
code read
i00 User interface off & remaining time adaptation off
i10 Cycle pause and request to user to confirm to re-start
i11 Cycle pause and request to user to confirm to restart
i20 Cycle pause and request to user to confirm to re-start
i30 Cycle stop and continuous automatically after problem solved – rta off
i41 Cycle will be terminated, electronic stop after on/off or failure solved
electronic will switched to reset on-condition
i42 Old calibration will be used, cycle continues
i43 Cycle will be terminated, electronic stop after on/off or failure solved
electronic will switched to reset on-condition
i44 Cycle will be terminated, electronic stop after on/off or failure solved
electronic will switched to reset on-condition
i45
Old calibration will be used, cycle continues
i46 Old calibration will be used, cycle continues
i51 Cycle will be terminated and electronic switched to reset on-condition
i52 Cycle will be terminated and electronic switched to reset on-condition
i53 Cycle will be terminated and electronic switched to reset on-condition
i54 Cycle will be terminated and electronic switched to reset on-condition
i55
Cycle stop and continuous automatically after probl. Solved – rta off
i56 Cycle stop and continuous automatically after probl. Solved – rta off
i57 Cycle will be terminated and electronic switched to reset on-condition
i57
Cycle will be terminated and electronic switched to reset on-condition
Dishwashers before
March 2017
User indication
Nothing
i10
i10
i20
i30
i40
Nothing
i40
i40
Nothing
Nothing
i50
i50
i50
i50
i50
i50
i50
i50
4
Chapter