Specification - scope F-LINK MK4 Installation Manual

Supply voltage:
Power consumption:
Transmitter output:
Frequency range:
Channel spacing:
Receiver Blocking:
Receiver sensitivity:
Radio standard:
EMC standard:
Safety standard:
EU Conformity:
Inputs:
Outputs:
Text descriptions:
Control ports:
Configuration:
Footprint (mm):
Scope's policy is one of continuous development. Specification is subject to change without notice.
Ref: FLNK4red
F-Link Mk4 Supervised Transceiver System

9. Specification

10-30V dc, 500mA
~50mA (standby)
~300mA (transmitting)
+25mA per active relay
500mW ERP max
458.5125MHz to 458.9375MHz
12.5KHz
Category 1.5 (Improved Performance SRD)
-117 dBm
EN 300 220-2 V3.1.1 (2017-02)
EN 301 489-2 V2.1.0 (2017-03)
EN 60950-1: 2006+A2: 2013
Radio Equipment Directive 2014/53/EU
4 x volt-free zone inputs
(Can be set to normally-open or normally-closed)
1 x volt-free fault input
(680 end-of-line, triggered by open- or short-circuit)
1 x volt-free remote reset input (normally-open)
4 x configurable volt-free zone output relay
1 x fault/test output relay
(all changeover relays 50V 0.5A max)
Individual Node name (16 characters)
4 x input trigger messages (16 characters each)
4 x input clear messages (16 characters each)
USB port for programming function
9-pin RS232 port for interconnection to other systems
Node address and operating frequency via DIP switches
Operation and function via PC software (available from Scope)
330w x 190*h x 70d mm (*excluding aerial)
Page 23 of 23
Issue 1