Table of Contents
Advertisement
18
en | Equipment estimation
4.
5.
6.
7.
8.
9.
Using a maintenance SE transmitter with two people
1.
2.
3.
4.
5.
6.
Reviewing potential problem areas
Review the potential problem areas on the maps with the customer to see which areas cause
them concerns, and which areas they consider acceptable. If the customer considers an area
acceptable, it is typically not worth spending additional time trying to improve the location
accuracy in those areas.
2018.03 | SE3v1.0 | DOC
Continue to the next location, transmit and mark that spot on the map with a "2." Repeat
the process throughout the area to be tested, being sure not to exceed 50 alarm
transmissions and making sure that at least 10-sec. elapse between transmissions.
When finished, return to the computer and select menu File > Maintenance Alarm
Database. Scroll through the alarm list to find the alarm that matches the time of your
first transmission. This is the maintenance alarm that you marked as "1" on your map.
Confirm that the actual location from the map matches the reported location.
If the actual location differs from the reported location, draw an arrow on the map from
the actual location to the reported location. Press the up arrow once to go to the next
alarm. Compare the locations, drawing an arrow to the reported location if they differ.
Repeat this procedure for all points on your map, making sure that the points on the map
stop when you run out of entries in the scrolling list on the computer screen. Otherwise,
the points on the map and the screen are out of sync and the errors on your map are
incorrect and misleading.
For areas where there were alarm location problems, you may want to repeat the above
process facing in different directions from the same spot. This generates additional
alarms from different spots in the problem areas to fully understand the extent of the
problem.
You should also generate alarms in areas adjacent to the area with the problem to see if
they are also affected.
The two people must have radio contact between them. One person operates the
computer running the Security Escort software and the other takes the maintenance SE
transmitter to the area to be tested.
At the computer, select menu File > Maintenance Alarm Database. Make sure the top
item in the scrolling list is selected.
Press the alarm on the SE transmitter and remain at the spot where you transmitted. At
the computer, observe the alarm and accurately describe the computed location over the
radio. The individual with the SE transmitter should confirm the reported location or
describe the actual location over the radio. Either individual must record all
discrepancies, including the actual and computed locations. We recommend using a map
or floor plan and drawing an arrow from the actual alarm location to the reported
location. It is also helpful if all successful alarm locations are marked with a P (passed).
For areas where there are alarm location problems, try facing in different directions from
the same spot.
Generate additional alarms from different spots to fully understand the extent of the
problem.
You should generate alarms in areas adjacent to the area with the problem to see if they
are also affected.
Hardware Installation Manual
Security Escort
Robert Bosch (SEA) Pte Ltd
Advertisement
Table of Contents
