Table of Contents
Advertisement
Standalone Play of Sounds (PREVIEW)
You can use the note-entry buttons on the unit to play notes (Preview function).
fig.001
1
1
Press [PREVIEW].
[PREVIEW] lights up in red, and the buttons you can use in the preview mode (note-
entry buttons) light up in orange.
2
Press any of the note-entry buttons to play a note.
You will hear the note assigned to the button you press.
fig.002
C# D#
C
D
E
To cancel the Preview function, press [PREVIEW] again to turn off the button.
How to Change the Volume
Turn [OUTPUT] to change the volume.
2
F# G# A#
F
G
A
B
C
Producing Sound
You can raise or lower the
octave setting by pressing [-
OCT] or [+OCT] to the right of
[PREVIEW].
Each time you press [-OCT],
the octave goes down. Each
time you press [+OCT], the
octave goes up. You can shift
by up to four octaves in either
[OUTPUT]
direction. You can check the
current octave through the
blinking of the button. To
restore the original conditions,
press [-OCT] and [+OCT]
simultaneously.
If you press [HOLD] (lights up
in red), you can have the note
continue to play after you
release the note-entry button
(Hold function). When a note
is played using the Hold
function, the note-entry button
blinks in amber. To stop the
held note, press the note-entry
button again.
To cancel the Hold function,
press [HOLD] again to turn off
the button.
By holding down [PREVIEW]
and pressing [VALUE
you can set the Velocity value
(000–127) for the notes played
with the note-entry buttons.
However, this setting is not
saved.
/ ],
21
Advertisement
Table of Contents
