Before You Begin Playing; Setting Up For Performing; Attaching The Music Rest; Using The Music Holders - Roland HPi-6s Owner's Manual

Before You Begin Playing

Setting Up for Performing

■ Attaching the Music Rest

The music rest of the HPi-6S contains a liquid crystal display screen.
Use the following procedure, and handle the music rest with care.
1.
Secure the music rest in place by turning the included
screws (at two points).
When attaching the music rest, support it firmly with one hand to
make sure that you don't drop it. Be careful, so you don't get
your fingers pinched.
fig.MusicRest
Screw
2.
Connect the LCD cord of the music rest to the LCD Out
connector on the rear panel of the HPi-6S.
The power must be off when connecting the cable of the
NOTE
music rest.
fig.LCDCord-e
Do not apply excessive force to the installed music rest.
NOTE
Be sure to use the supplied screws for attaching the music
NOTE
rest.
Before moving the piano, be sure to remove the music rest to
NOTE
prevent accidents.
Be careful not to lose the screws used to fasten the music
NOTE
rest, or allow small children to accidentally swallow them.
16
View from Rear
Screw
LCD Cord

■ Using the Music Holders

You can use the holders to hold pages in place.
When not using the holders, leave them folded down.
fig.MusicHolders

■ Connecting the Pedal Cord

1.
Insert the end of the pedal cord extending from the piano
stand to the Pedal connector located at the lower part of
the HPi-6S's rear panel.
fig.PedalCord
Pedal Cord

■ Connecting the Power Cord

1.
Make sure that the [Power] switch located at the left side
of the front panel is off (in the upward position).
Upward
position
2.
Turn the [Volume] knob all the way toward the left to
minimize the volume.
3.
Connect the included power cord to the AC inlet located at
the rear of the bottom panel.
Lower
position
On
OFF