Getting Ready To Play; Check The Connections Between The Sound Module And The Pad; Install The Batteries - Roland RMP-12 Owner's Manual

Getting Ready to Play

• Avoid outdoor use (practice) in rainy conditions. Such
use will cause malfunctions.
• Take care that dirt or other foreign matter does not
enter the inside of the unit from the underside of the
pad. Such foreign matter will cause faulty operation or
malfunctions.
• Do not insert your hand or fingers from the rear of the
pad. Doing so may cause injury to you, or may cause
the unit to malfunction.
Check the Connections between the
Sound Module And the Pad
fig.triggerin.eps
TRIGGER OUT
jack
1.
Make sure that the cable that connects the
TRIGGER IN jack on the sound module's side panel
to the TRIGGER OUT jack of the pad is connected
securely at both ends.
This cable is connected when the RMP-12 is shipped from
the factory.
Make sure that the plug is NOT in the position shown in
the photo below.

Install the Batteries

1.
2.
TRIGGER IN
jack
3.
Loosen the two screws that fasten the cover of the
battery compartment, and remove the cover.
Install the supplied batteries into the battery
compartment, while carefully observing the
correct polarity (+/- orientation).
Insert the batteries from above the battery ties. Make sure
that the ends of the battery ties are not hidden below the
batteries.
As shown in the illustration, insert the batteries in order,
beginning at the top. You should insert the "+" end of each
battery first.
Battery ties
Firmly close the cover of the battery compartment,
and fasten it using the screws you removed in step 1.
Be careful not to pinch the battery ties when you close the
battery cover.
Battery ties
Battery cover
11