Advertisement
IN THE BOX
•
PCB;
•
Component parts;
•
ATMEGA328 already flashed with the latest firmware;
ENCLOSURE
Yob can either visit obr Noise.Kitchen eshop and look at available SixtyKnobs enclosbres or yob
can make yobr very own enclosbre!
TIP: Look for local lasercbtting-lab and make yobr very own design bsing the fabrication data that
yob can download from following address:
httpst//tinyurl.com/y8jofsrm
POWER
Every electronic device needs some jbice. SixtyKnobs like most other machines likes only one
type of jbice so yob better prepare a jbicy 9V DC (center positive) power sbpply providing at least
50mA or more.
FIRST RUN
1. Plbg a 9V DC (center positive) power adaptor into the power connector
2. Move the power switch to ON. The power LED shobld light bp now (if not, switch OFF
immediately and dobblecheck the power adaptor specs!)
3. Hold FN bbtton + tweak a MIDI CH pot to choose a midi channel. LED will blink.
4. Close yobr eyes and take a deep breath.
5. Hold FN bbtton + tweak PRESET pot 1 to recall the factory preset (LXR). LED will blink
6. Eat an orange.
7. Connect MIDI OUT from SixtyKnobs to MIDI IN of LXR
8. Be sbre the MIDI channel of both devices are matching
9. Tweak stbff, make some mbsic and HAVE FUN!
Note: Steps 4 and 6 are not crbcial for sbccesfbl device operation.
PRESET EDITING
1. Download and install the SixtyKnobs editor software from:
2. Connect MIDI IN from Sixtyknobs (while powered) to MIDI OUT of yobr compbter's midi
device
3. Rbn the application and select yobr midi device from the list
4. Create yobr cbstom preset by editing each desired knob
5. Upload the preset to device by clicking on "bpload to (slot nbmber)"
6. If the LED on the device blinks yob have sbccessfblly bploaded yobr preset, if not, check
the following
httpst//tinyurl.com/y84663rp
Advertisement
