System Configuration - Toshiba Estia RUA-CP1701H Installation Manual

Monobloc Outdoor Unit
8.0 System configuration
Internal parameters are software codes that can be adjusted to optimize the performance of the system depending
on the installation and the customers' requirements.
There are 3 access levels for the system Parameters:
1. Access to parameters not allowed
2. Access to end user parameters only
3. Access to End User and Service parameters
Details of the parameter setting procedure and a list of available parameters are shown in the following sections.
8.1 Parameter setting procedure
The parameters, used to optimize the performance of the system, are accessed using the remote controller:
There are two steps required to set up the system parameters:
8.1.1 Initial step of configuration: Setting the time and day
Before using any parameter menu on the WUI, it is necessary to set the time and day of the control.
The following sections explain the procedures for unit with user interface. If there is no user interface on the unit, it
is necessary to use Customer communication bus (Proprietary Protocol or Jbus) to configure the unit
To access the time configuration menu, press and hold the Schedule key for 2 seconds.
Schedule
Occupancy
Mode
Down
37
Up
Installation Manual
.